The  COMPUTHERM  Q32 room  thermostat  has  been  specifically  designed  to  control  heating  and cooling systems. In addition, the thermostat is also suitable for controlling electrical and electronic devices which can be turned on and off by interrupting and resuming power supply.

Two 1.5 V alkaline batteries (type: LR6, size: AA) are required for the operation of the appliance. Only good quality alkaline batteries may be used. Other batteries known as durable or long life batteries (conventional  carbon-zinc  batteries),  half  dead  batteries  and  chargeable  accumulators  are  not suitable for the operation of this appliance.

In normal use the expected lifetime of the batteries is approx. 1.5 to 2 years.

It means that the temperature measured by the appliance falls outside the measurement range of the temperature sensor: LO indicates that the temperature is too low, while HI shows that the temperature is too high. This may occur when the appliance is in an extremely cold or warm environment or the temperature sensor suffers a physical damage (e.g. it gets crushed with the effect that the two pins of the temperature sensor touch or the temperature sensor breaks off) or the temperature sensor becomes defective for some other reason.

COMPUTHERM Q32 type switching-mode room thermostat is able to control vast majority of the boilers and air-conditioning equipment available on the Hungarian market. It can be easily connected to any gas boiler having a two-wire thermostat connection point and to any air conditioning apparatus or electrical apparatus, regardless of whether they have a 24 V or 230 V control circuit. In addition, the thermostat is also suitable for controlling electrical and electronic devices which can be turned on and off by interrupting and resuming power supply.

No. Two 1.5V alkaline batteries (type: LR6, size: AA) are required for the operation of the thermostat.

It is expedient to locate the thermostat on the wall of a room where you stay regularly or a long period of time so that the thermostat is oriented in the direction of the natural ventilation of the room but is not exposed to draught or extreme heat (e.g. sunlight, refrigerator, chimney, etc.). Do not use in wet, chemically aggressive or dusty environment. Its optimal location is at a height of 0.75-1.5 m from the floor level.

The appliance must be installed / put into service by a competent person. The device to be controlled should be connected to 1-2 connection points located on the back side of the thermostat. For a more detailed description please refer to the Instruction Manual of the product.

Yes. You can switch between heating and cooling modes of the thermostat. According to the selected switch sensitivity, in cooling mode the thermostat will turn on the air-conditioning equipment above the set temperature and turn it off below this temperature.

There are various reasons for this. The most frequently encountered problems are:

•     unsuitable batteries (e.g. dead batteries or non-alkaline batteries) are being used
•     incorrect connection (which, in unfortunate cases, can destroy the relay in the appliance or the electronic system of the controlled device)

The appliance has potential free (voltage free) output connection points therefore 230 V voltage normally does not appear at its outputs, it only links the two connected wires or disrupts the connection between them. If you want 230 V voltage to appear at the output of the appliance when it is switched off then you have to connect a mains phase wire to connection point 1 or 2 of the appliance according to the Instruction Manual. Before connection the phase wire must be de- energized and the connection must be carried out by a competent person.

Inside the thermostat there is an orange-coloured potentiometer that can be adjusted by a screwdriver. When you rotate the potentiometer clockwise then the displayed temperature will be lower after a short while, and when you rotate it anticlockwise the displayed temperature will become higher.

Search  this  product  at  our  reseller  partners.  The  list  of  our  reseller  partner  is  available  at  the following link: Partners

Installing and operating instructions for the Q32 thermostat are available at the following website: Instruction Manual.